![]() (She hasn’t had enough scissor experience yet to know that she could have just opened up the scissors to their sharpest point and let them glide through the cellophane instead).Īlways the lateral thinker, JJ found some old Australian flag tattoos to cut up instead, discovering that their tacky surface sticks to the underside of the cellophane quite nicely. You can see the teeth marks in the cellophane above where JJ has tried to make cuts with the blunter ends of the scissors and didn’t have much luck. After a few safety tips regarding electricity, I let them play…Īt first JJ tried cutting the cellophane with each of the scissors, and this was actually more difficult than I had realised. I chose a few coloured sheets of cellophane and some scissors for their first light table exploration. (Yay, it worked!).Īnd then it is time to turn out the lights… Then place your light box on either the floor or a low table, and plug it in to check if any of the bulbs are broken. I didn’t worry about that though, as in our case the cord was thin enough that the box could still close easily with the cord hanging over the edge.) (If you wanted to put your fancy pants on, you could cut a small section out of the top of the box to run the cord through. Ours was recycled from old wrapping paper, so had a few creases and it still worked just fine. Then stick a sheet of tissue paper to the inside of the lid. clear Christmas lights with a thin electrical cord. (Some types of coloured Christmas lights actually use clear bulbs with a plastic coloured filter on top – these should also work if you remove the coloured filters.)įirst, line the inside of the box with aluminium foil, shiny side up, using the tape to attach.basic kitchen aluminium foil (and yes, I seem to be on an aluminium foil roll at the moment…lol).some sort of low under-bed storage box with a plain transparent lid.To make a DIY Light Table like ours, you’ll need: There’s a good chance you might have some of the items at home already, and the rest you should be able to get from your local discount store or online. My version is no where near as fancy. But it is quick, easy and relatively low cost. There are lots of DIY light tables and light boxes that involve paints, primers, drills, perspex and fancy electronics. I keep joking that she was going to inspire me to make a DIY Light Table for myself one day. You see, this all came about because Dyan from And Next Comes L kept sharing these amazing light table posts on my Facebook wall.
0 Comments
Leave a Reply. |